Figure 47 Mdf Cable Line Connection On 7360 Isam Fx-16 - Nokia 7360 Intelligent Services Access Manager FX Series Hardware Installation Manual

7360 ISAM FX-16 shelf cabling
Procedure 19
Proceed as follows to connect the MDF cables for LINE and POTS to the LT card with integrated
splitter:
1
Figure 47
2
3
4
118
To connect MDF cabling for LT cards with integrated splitter
Connect the MDF cable for the LINE to the right-hand CHAMP connector on the LT card with
integrated splitter, as shown in Figure 47.
MDF cable LINE connection on 7360 ISAM FX-16
PWR PWR
ALM ALM
MAJ
01 02 03 04 05
R
ESD
CAUTION
ROTATING FAN BLADES
CRAFT PORT
Secure the connector with standoffs and nuts.
Route and connect the other end of the MDF cable as per site practices.
Connect the MDF cable for the LINE to the left-hand CHAMP connector on the LT card with
integrated splitter, as shown in Figure 48.
3HH-12893-AAAA-TCZZA
ANSI Hardware Installation Manual
06 07 08 NTA NTIO NTB 09 10 11 12 13
CRITICAL
Energy Hazard
MAJOR
7360 ISAM FX-16
-48V 70A
MINOR
ALM Energy Hazard
BITS INTERFACE
TIME OF DAY
NT-A NT-B
RING 1 Hz-PULSE
TIP
CAUTION: BEFORE REMOVING TERMINAL COVER,
FRAME GND
CRAFT PORT DISCONNECT BOTH "A" AND "B" POWER SOURCES
CAUTION: TORQUE NUTS TO 65 IN-LBS MAX
BITS INTERFACE
TIME OF DAY
NT-A NT-B
1 Hz-PULSE CO ALARMS
RING
TIP
FRAME GND
DRAFT
14 15 16
BAT A
BAT B
ACO
CO ALARMS
23890
Issue: 09