Adapting Individual Parameters - Siemens SINUMERIK 840D sl Commissioning Manual

11/2006
Example
8.8.4

Adapting individual parameters

© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl Commissioning Manual CNC: ShopTurn – 11/2006 Edition
;============================================
[TOOL_LIST_OEM]
=============================================
;Default values for columns
COLUMN1 = LENGTH3
COLUMN2 = DLENGTH3
COLUMN3 = TPC1
COLUMN4 = TPC2
COLUMN5 = NOT_USED
COLUMN6 = NOT_USEDY
COLUMN7 = NOT_USED
COLUMN8 = NOT_USED
COLUMN9 = NOT_USED
COLUMN10= NOT_USED
COLUMN11= NOT_USED
COLUMN12= NOT_USED
In the example list, the following columns are to be displayed:
Column 1: Tool length Y
Column 2: Wear Y
Column 3: 1st user–specific parameter
Column 4: 2nd user–specific parameter
You have set the following machine data for the example shown:
MD 18080 $MN_MM_TOOL_MANAGEMENT_MASK, bit 2
Provide memory for user data
MD 18094 $MN_MM_NUM_CC_TDA_PARAM=2
For each of the user–defined parameters (TPC1 and TPC2)
MD 18095 $MN_MM_TYPE_CC_TDA_PARAM[n]=4
Data type (REAL) of user–defined parameters
MD 20310 $MC_TOOL_MANAGEMENT_MASK, bit 2
Activate user functions
Using the configuration file to_turn.ini, you can change the default settings for
specific tool parameters.
Table 8-5 PARAMETER_IDENTIFIER
PARAMETER_IDENTIFIER
T_MAG_PLACE_TYPE
TPC1
TPC2
TPC3
TPC4
TPC5
8.8 Configuring the operator interface
; screen OEM tool list;
Magazine location type
Parameter 1
Parameter 2
Parameter 3
Parameter 4
Parameter 5
8 Tool Management
Parameter
8-117