Initial Start-Up; Sequence - Siemens SINUMERIK 840D sl Commissioning Manual

11/2006
4.2 Initial start–up
4.2.1

Sequence

© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl Commissioning Manual CNC: ShopTurn – 11/2006 Edition
Before you begin startup please read the general conditions and reserved functions.
For installation and startup proceed as follows:
S
For installation of ShopTurn on PCU from CD (only for ShopTurn on PCU 50.3).
For ShopTurn on NCU (HMI embedded) the ShopTurn software is already pre–
installed.
S
PLC commissioning
S
NCK commissioning
S
Install additional functions (optional)
S
Adapt display machine data
S
Customize the operator interface (optional)
S
Run a test using the acceptance certificate
You can start up tool management either together with NCK and PLC startup or
afterwards. If tool management is already set up on the machine you only need
to adapt the display machine data for tool management; (see Section 8.2
"Startup sequence").
A detailed description of commissioning is provided in the following documents:
References: /IDS/, Commissioning Manual CNC Part 1 (NCK, PLC,
Drive), SINUMERIK 840D sl,
/IAM/, Commissioning Manual CNC Part 2 (HMI),
SINUMERIK 840D sl/840D/840Di/810D
4 Commissioning
4.2
IM2 Commissioning HMI Embedded (sl)
IM4 Commissioning HMI Advanced
Initial start–up
4-19