Machine Data; Nck Machine Data For Shopturn - Siemens SINUMERIK 840D sl Commissioning Manual

Machine Data

7.1

NCK machine data for ShopTurn

© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl Commissioning Manual CNC: ShopTurn – 11/2006 Edition
In order to put the NCK into service all relevant NCK machine data (including
tool management data) must be set with the ShopTurn–specific values.
In the operating area "Tools – zero" open the mask "Machine data" by pressing
the softkey "Machine data" in the extended softkey bar. Here all the machine
data needed for ShopTurn is displayed with information regarding setpoint and
actual values.
Correctly set machine data is marked with a check mark. Machine data that is
marked with an exclamation point must be corrected accordingly. A red ex-
clamation point in the header (No., MD, Set, Actual) will indicate when it is nec-
essary to correct machine data.
The following symbols indicate the rule for setpoint to actual value:
S
+: must be exact
S
v: must be at least
S
&: certain bits must be exact
If no rule is indicated for setpoint to actual value, it is only a suggestion.
NCK machine data with exact values must be set as specified. NCK machine
data with minimum values can be adapted to the specific features of your ma-
chine.
The activation mode for each item of machine data is indicated in the column
after the actual value display.
S
po : Power On (softkey "NCK reset")
S
cf : Configuration (softkey "Set MD effective")
S
so : Immediately (no action required)
S
re : Reset ("Reset" key on machine control panel)
Note
Files SIEMENSD.RTF and SIEMENSE.RTF list the necessary settings for the
ShopTurn machine data. You are advised to print these out. You can then
check and if necessary correct the specific values more conveniently.
7
7-41