Checking The Battery Status; Charging Mobile Devices With The Power Bank - Silvercrest SPBL 6000 A1 Operation And Safety Notes

The current battery status is shown by LED display
during the charging process.
* This is approx percentage of power bank capacity but not
actual measurement.
WARNING Do not connect any device to be charged
to power bank as long as the power bank is charging.
Remove the charging cable from the power bank when
it is fully charged.

Checking the battery status

You can check the battery status on the LED display
power bank anytime.
The current battery status is shown flashing on the display
for about 30 seconds. The display then goes out and
2
the user has to lightly press the LED ON / OFF button
to switch the display back on.
* This is approx percentage of power bank capacity but not
actual measurement.
Charging mobile devices with
the power bank
You can charge up to three devices at the same time using
the power bank
the sum of the discharging power may not exceed 3 A.
Connect the USB cable
of the device to be charged to one of the two USB output 1
or output 2
6
cable can be connected to the USB Type C connector
And then connect micro-USB port of the USB cable
the micro-USB input of device to be charged. The charg-
ing process will start automatically.
In case if the charging process does not begin immediately,
press the LED ON / OFF switch
. If all outputs are used at the same time,
1
8
. Devices with a USB Type C connection
3
or the original charging cable
lightly to begin the
7
2
of
2
7
.
4
to
8
GB/IE 25