Troubleshooting - Silvercrest SPBL 6000 A1 Operation And Safety Notes

charging process. The current battery status of the power
bank is displayed during the charging process by
1
the LED display
To end the charging process, disconnect the USB charg-
ing cable from the mobile device and the power bank
The power bank will switch OFF and the LED display
will switch off after approx. 30 seconds.
Or simply double click with LED ON / OFF switch
The power bank and the LED display

Troubleshooting

= Problem
= Cause
= Solution
The power bank
It may be that the power bank is not connected properly.
Check that it is connected.
In order to charge the power bank, a power supply with
5 V and at least 3 A has to be used.
A connected device is not being charged.
The battery is drained.
Charge the battery.
The device is not connected.
Check that it is connected. Lightly press the LED
ON / OFF switch
The current consumption of the connected device might
be too low.
Check with your connected device manual and see if
your connected device current consumption comply with
this product.
26 GB/IE
.
2
is not being charged.
1
to begin the charging process.
7
7
will switch off.
2
.
1
2
.