Troubleshooting - Silvercrest SBDB 5 A1 Operating Instructions And Safety Instructions

Troubleshooting

If you cannot connect the radio to a compatible Bluetooth
proceed as follows:
Make sure that the Bluetooth
♦
device.
Make sure that the radio is switched on and that the Bluetooth
♦
is activated.
♦ If you use several external playback devices, ensure that any previously
made connection is disconnected. There may be a previously paired play-
back device still within range.
♦ Make sure that the radio is no more than 10 metres from the external
playback device and that no obstacles or electronic devices are placed
between them.
The following table helps to identify and rectify further possible faults:
Fault
There is nothing on
1
the display .
No sound.
■ 24 │ GB │ IE │ NI
Possible cause
The mains adapter is not
correctly connected.
The mains socket is not
supplying any power.
There are no batteries in the
battery compartment
the batteries are dead.
The batteries are inserted
incorrectly in the battery
e
compartment .
The device is not switched on.
The volume is set to minimum.
In AUX mode, the external play-
back device is not turned on.
The external playback device
is muted in AUX operation.
In AUX mode, the 3.5 mm
t
jack cable is not
correctly connected.
®
function is activated on the playback
Remedy
Make sure that the mains adapter is
correctly connected with the mains
adapter connection
mains socket.
Check the house fuses.
Check that the batteries have
e
or sufficient charge and replace them if
necessary.
Check whether the batteries are insert-
ed the right way round in the battery
compartment
into the battery compartment
shown on the polarity diagram.
Switch on the device by pressing
the button
Increase the volume using the
VOLUME dial
Switch on the external playback
device.
Unmute the external playback device.
Make sure that the 3.5 mm jack
t
cable is correctly connected to the
external playback device.
®
playback device,
®
function
r
and with a
e
. Insert the batteries
e
as
2
.
5
.
SBDB 5 A1