Installing The Snap-In Sewing Table; Inserting The Needle - Silvercrest SNM 33 C1 Operation And Safety Notes

Getting ready

Installing the snap-in sewing table

Inserting the needle

C
10 US-EN
D
A
B
If you want to sew on the arm bed, pull
out the snap-in sewing table (7) in the
direction of the arrow.
The inside of the snap-in sewing table (7)
can be utilised as an accessory box.
The included accessories can be found
inside the snap-in compartment.
Important:
Turn the power switch (20) to off ("O").
Change the needles regularly, especially
Insert the needle as in the illustration.
A. Loosen the needle clamp screw and
tighten again after inserting the new
needle.
towards the back.
C/D. Insert the needle up to the stop at the
end of the shaft.
Only use fully-functional needles:
Problems can occur with the use of:
- Bent needles
- Blunt needles
- Damaged points
at the first signs of problems when sewing.
B. The flat side of the shaft should be