Automatic Needle Threader - Silvercrest SNM 33 C1 Operation And Safety Notes

Getting ready

Automatic needle threader

C
1
2
3
4
14 US-EN
B A
D
E
Attention:
Turn the power switch (20) to off ("O")
before threading the needle.
Important:
Raise the needle to its highest position
by turning the hand wheel toward you
until the mark (A) matches with the line
(B) on the machine.
1. Lower the presser foot. Pass the thread
around the thread guide (C).
2. Press the lever down as far as it goes.
The needle threader turns automatically
to the threading position and the tiny
hook pin passes through the needle eye
(D).
3. Take the thread in front of the needle
and make sure it is under the hook
pin (E). Then hold the thread slightly
upwards so that it hangs on the hook.
4. Hold the thread loosely and release
the lever slowly. The hook will turn and
pass the thread through the eye of the
needle, forming a loop. Pull the thread
through the eye of the needle.