View Mode - ABB Navigator 500 Series Operating Instructions Manual

Navigator 500
Sodium analyzer

6.6 View mode

Pages displayed in View mode comprise:

Diagnostics View – displays a list of diagnostic messages identified by priority and message – see Fig. 6.6

Alarms View – displays a list a list of alarms identified by priority (sequence number), source and status – see Fig. 6.7

Outputs View – displays a list of alarms identified by analog output ID, output value and percentage of output value
– see Fig. 6.8

Signals View – displays a list of active signals and their values – see Fig. 6.9

Chart View – represents the wet-section readings as a series of color-coded traces – see Fig. 6.10
NAMUR icon and message priority –
Fig. 6.6 Diagnostics View
Fig. 6.7 Alarms View
Fig. 6.8 Outputs View
OI/ASO550–EN Rev. G
Diagnostic message
see page 72
Diagnostics View
No. Message
Temp Failure S3
01
NV Error S3
O2
Calibrating S3
O3
O4 Recovery S3
Setpoint
Alarms View
ID Setpoint
Alarm ID
A1 100.0 ppb
A2 100.0 ppb
A3
100.0 ppb
A4 100.0 ppb
A5 – – – –
A6
– – – –
A7
– – – –
A8
– – – –
Output value
Outputs View
ID Output
Analog
4.00 mA
AO1
output ID
4.00 mA
AO2
AO3 4.00 mA
AO4 4.00 mA
View icon
2012–04–15
10 : 31: 27
CAL
Alarm status
Alarm source
2012–04–25
10 : 31: 27
Source Status Ack



CAL
% of output value
2012–04–15
10 : 31: 27
Percent
0.0 %
0.0 %
0.0 %
0.0 %
CAL
6 Operation overview – transmitter
Alarm acknowledge
status (Y / N)
33