ABB Navigator 500 Series Operating Instructions Manual page 53

Navigator 500
Sodium analyzer
...Menu
Settings
Brightness
Contrast
Date & Time
Date Format
Date & Time
Daylight Saving
DS Region
DS Start Time
DS End Time
DS Start Occur
DS End Occur
DS Start Day
DS End Day
DS Start Month
DS End Month
OI/ASO550–EN Rev. G
Comment
Sets the following display parameters.
Increases / decreases the device's brightness settings to suit local
environmental conditions.
Increases / decreases the device's contrast settings to suit local
environmental conditions.
Sets / formats the device's date, local time and daylight saving start /
end times:
DD–MM–YYYY / MM–DD–YYYY / YYYY–MM–DD.
Sets the device date and time in the format: (date format set at Date
Format menu) XX–XX–XXXX / time (fixed format) HR:MINS:SEC.
Sets the daylight saving parameters.
Selects the geographical region daylight saving hours are based on:

Off – daylight saving is disabled.

Europe – selects standard daylight saving start and end times
automatically.

USA – selects standard daylight saving start and end times
automatically.

Custom – used to set custom daylight saving start and end times
manually for regions other than Europe or USA.
Note: The DS Start Time / Occur / Day / Month and Time menus
(below) are activated only when Custom is selected at the DS
Region menu.
Sets the daylight saving start time and end time, selected from
1-hour increments.
Selects the day within the month that daylight starts / ends – for
example, to set daylight saving to start (or end) on the second
Monday of the selected month, select Second.
Sets the day of the month daylight saving starts / ends.
Note: The DS Start Occur / DS End Occur parameters must be
valid within the month for the selected day.
Sets the month daylight saving starts / ends.
7 Menu descriptions
Default
DD-MM-YYYY
01.01.2000
Off
51