®
ABB i-bus
EIB / KNX
4
Project design and
programming
4.1
Overview of the functions
Application program
Room Controller modular, 8f/1
4.2
General functions
4.2.1
Parameter window:
"General"
© 2004 ABB STOTZ-KONTAKT GmbH
Project design and programming
The Room Controller has a single application program "Room Controller
modular, 8f/1" which is used to set the device function. The programming
requires the EIB Tool Software ETS2 V1.3a or higher.
Number of
communication objects
246
The operating mode of the output is set in the first parameter.
Parameter: "Operating mode of output"
The function of the output can be selected here. The options available are
"Switch actuator", "Heating actuator" and "Fan coil control".
The other parameters are dependent on the selected operating mode.
See under section 3.1 for further explanations about the operating modes.
Max. number of
group addresses
254
Max. number of
associations
255
25