Figure 4-2 Outward Of Gpio Cable And Connector - Hitachi HF-BX1000 Instruction Manual

(3) Recommended specification of GPIO cable
Do not connect the No. 1 pin and No. 2 pin of GPIO contact. When these are
●
connected to the connector on the user's equipment, this equipment may not
operate normally.
Make sure to confirm connector specification before creating a cable by a user.
●
If a user connect a cable which was mistaken about connector specification to
this equipment, this equipment may not operate normally.
Prepare the GPIO cable that conforms to the recommended specifications shown below by a user.
Connector for GPIO
6 1
9 5
(*1) The maximum cable length is 1.5 m. The cable length should use less than 1.5 m.
(*2) Contact the shield ground of a cable to the conductor of a plug case(frame ground)certainly.
In addition, since all the GND pins of GPIO are the signal grounds, do not connect a shield
ground. If you do, it may occur the malfunction.

Connector specification of EXT side (recommendation)
Part's name
Plug case
Male connector

Cable specification (recommendation)
Maximum cable length
Electrical cable shield
Recommended cable
Pulg case

Figure 4-2 Outward of GPIO cable and connector

Connetor form：D-sub 9 pin Male connector
DE-C8-J9-F1-1R
Item
UL2464SB 5P×24AWG
NOTICE
Model
DEU-9PF-F0
Specification
1.5m
Necessity
4-19
4. SPECIFICATIONS
Cable (*1)(*2)
User equipment side
connector form：
unite with a user's
equipment.
Maker
JAE
JAE
Remark
Connect to frame ground
Hitachi Metals