Table 2-1 Function Of Each Part - Hitachi HF-BX1000 Instruction Manual

Industrial computer

Table of Contents

2. PHYSICAL CONFIGURATION

Name

Power switch

Reset switch

Power lamp

HDD1 status lamp/

HDD2 status lamp

AC inlet

Power supply

PS/2 port (Mouse)

PS/2 port (Keyboard)

Audio port (LINE IN)

Audio port

(LINE OUT)

Audio port (MIC)

Serial port

(9 pins: RS-232C-A)

Analog RGB port

HDMI port

Displayport

RM.SW/GPIO

Extension slot

USB port

Digital LED

for Status indication

[1]

[2]

[3]

Status indication LEDs

Table 2-1 Function of Each Part (1/2)

When you press this switch, the power is turned on. When you press the

switch for four seconds or more, the power is turned off and the system

goes into standby mode (for emergencies only).

Use this switch to perform a hardware reset (restarting the equipment).

Lights green when the equipment is operating.

The HDD status lamp lights green when it is being accessed. The HDD2

status lamp does not light even if you mount an HDD in drive bay 2 in the

A model.

For the lighting pattern of the lamps in the D model, see Chapter 8.

Used for connecting a power cord.

A power supply module with a wide-range input voltage (100 to 240

VAC).

Used for connecting a mouse. (Prepared by user)

Used for connecting a Keyboard. (Prepared by user)

An audio line input.

An audio line output.

Microphone input

You can use this connector to connect a device such as a modem that uses

a serial interface.