HP TippingPoint Series Hardware Installation And Safety Manual page 26

6. Attach the cables to the AC adapter. Refer to the following diagram:
Figure 3-5 TippingPoint 10 Power Adapter Bracket
a. Slide the AC power cord through the retention camp on the wall mount plate and plug the cord into
the AC socket on the adapter.
b. Ensure the AC adapter is securely placed and screw the retention clamp down over the AC cord
connector.
c. Route the AC power cord through the cable guidesand connect to AC power.
d. Attach the DC power output of the adapter to the back of the TippingPoint 10.
To attach the TippingPoint 10 to a wall
To attach the TippingPoint 10 to a wall, hold the device and mounting plate vertically so that the network
ports are facing down. Use the four mounting holes in the plate to fasten the plate securely to the wall. The
screws should have a head diameter of at least 8mm (0.31 in) and a thread shaft diameter of at least 4mm
(0.16 in).
Figure 3-6 Positioning of the TippingPoint 10 On a Wall
CAUTION: When mounting the TippingPoint 10 on a wall, the device should only be mounted with the
ports facing down.
18 TippingPoint 10 Overview
MGM