Connect The Power; Setup Wizard - HP TippingPoint Series Hardware Installation And Safety Manual

Connect the Power

The TippingPoint 10 includes an AC/DC power adapter. Follow these steps to connect power to the device.
NOTE: You must always use the TippingPoint-supplied AC/DC power adapter with the TippingPoint 10.
Do not use any other power adapters with this device.
1. Plug the included AC/DC power adapter into the power input at the back of the device.
2. Plug one end of the provided power cord into the AC/DC adapter.
3. Plug the other end into an AC outlet, power strip, or UPS. The power should meet the following
requirements:
• Voltage: 1 10-240 VAC
• Current
• At 1 10 V: 1.1 1 Amps
• At 240 V: 0.414 Amps
• Frequency: 50-60 Hz
The unit starts automatically when power is first connected. The LED on the rear power button will turn blue,
and the Power LED on the front panel will turn green.
Using the Power Button
To power down the TippingPoint 10 while power is connected, press and hold the Power button on the
back of the device for four seconds, then release it. Press the Power button to turn the device back on.
If power is disconnected while the TippingPoint 10 is off, the device will start automatically when power is
re-connected. The first time that the TippingPoint 10 is unpacked and powered up and after the device is
powered off with the Power button, the Power LED will be red when power is connected. After the unit is
started by pressing the Power button, the power LED will be blue.

Setup Wizard

After you have powered on, the TippingPoint setup wizard displays on the COM port terminal. The wizard
prompts you to perform basic configuration tasks and periodically input information. You can run the
wizard through one of the following processes:
• Out-of-the-Box-Experience (OBE) Terminal Setup Wizard — Runs when the setup wizard is activated for
the first time or later with the
such as a workstation or laptop.
• Additional Configuration — After running the setup wizard using the serial terminal, you can configure
the system using subsequent setup commands through the Command Line Interface (CLI).
See the TippingPoint Command Line Interface Reference for detailed instructions.
NOTE: When using the command line interface, configure the terminal emulation package to transmit a
Ctrl-H character when the Backspace key is pressed.
command. This wizard is run on a serial port connected system,
SET UP
TippingPoint 10/110/330 Hardware Installation and Safety Guide 21