Configuration And Parameterization - Siemens SIMATIC CM35 Manual

3.3

Configuration and Parameterization

Table 3-6 Overview of configuration and parameterization
Configuration tool
Module address
Setting the operating mode
Parameterization
Configuration with
STEP 7
Configuration with
COM PROFIBUS
Parameterization
CM35 Counter Module
(4) J31069-D0416-U001-A5-7618
Configuration and parameterization of the CM35 depends on the system on
which the module is to be used.
Central Integration into
the SIMATIC S7-300
STEP 7, HW Config
Depends on slot or selecta-
ble as desired
(depends on CPU)
With SFC 55 "WR_PARM"
The object manager from the included data medium must be installed first
(see chapter 3.3.1) so that STEP 7 will be able to recognize the CM35 during
configuration.
The current GSD files must be loaded to subdirectory GSD so that
COM PROFIBUS is able to recognize the CM35 during configuration.
Parameterization is performed by the user program and only refers to the op-
erating mode which was set when the module was configured.The required
parameters depend on this operating mode.
The fundamentals of parameterization are described in chapter 4.2.
For details, see the descriptions of the individual operating modes.
Commissioning
Distributed Integration
into the SIMATIC S7
Can be selected as desired
During configuration
Distributed Integration
into the SIMATIC S5
COM PROFIBUS
Via I/O direct accesses
3-13