Siemens SIMATIC CM35 Manual page 44

Setting the
operating mode
Commissioning
CM35 Counter Module
(4) J31069-D0416-U001-A5-7618
The operating mode of the CM35 must have already been set during configu-
ration. Proceed as shown below.
1. In the configuration table, select the line with the CM35, and click the
button Param. ...
2. In the dialog box ²Parameterize...,² select the field under ²Value² in the
first line of the table (5), and click the Select... button. In the next dialog
box which appears, select the desired operating mode, and confirm with
OK.
3. Repeat this step in the second line of the table (8) with the same operating
mode. See figure 3-5.
4. In the ²Parameterize...² dialog box, click the OK button, and close the
configuration table with OK.
Figure 3-5 Setting the operating mode with COM PROFIBUS
Note
When distributed integration into the SIMATIC S5 is used, only the operat-
ing modes ²period duration measurement² and ²timer² (time generator) are
permitted. See chapter 1.2.
For additional preparations before operation, see the manual of COM PROFI-
BUS.
Commissioning
3-21