Siemens SIMATIC CM35 Manual page 65

Data Communication with the CM35
Table 4-10 Hardware interrupts in the various operating modes
Local Data of OB 40
Local data word 6
Local data byte 10
Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
Bit 7
Local data byte 11
Bit 0 Counter channel 1 has re-
ached the comparison va-
Bit 1 Counter channel 2 has re-
ached the comparison va-
Bit 2 Counter channel 3 has re-
ached the comparison va-
Bit 3 Counter channel 4 has re-
ached the comparison va-
Bit 4 Counter channel 5 has re-
ached the comparison va-
Bit 5 Counter channel 6 has re-
ached the comparison va-
Bit 6 Counter channel 7 has re-
ached the comparison va-
Bit 7 Counter channel 8 has re-
ached the comparison va-
4-18
(The function must have been activated before the interrupts are reported.)
Address of the module which triggered the hardware interrupt
Pulse Counter Period Duration
Measurement
Reserved No hardware inter-
rupts are reported in
this operating mode. thi
Pulse Counter Period Duration
Measurement
No hardware inter-
rupts are reported in
lue. this operating mode.
lue.
lue.
lue.
lue.
lue.
lue.
lue.
Hardware Interrupts
Operating Mode
Timer for
Selective Interrupt
(for Group Interrupt)
Timer 1 faulty
(malfunction of a timer)
ti d
Timer 2 faulty
(disregard)
Timer 3 faulty
(disregard)
Timer 4 faulty
(disregard)
Timer 5 faulty
(disregard)
Timer 6 faulty
(disregard)
Timer 7 faulty
(disregard)
Timer 8 faulty
(disregard)
Operating Mode
Timer for
Selective Interrupt
(for Group Interrupt)
Timer 1 has expired.
(a timer has expired)
Timer 2 expired
(disregard)
Timer 3 expired
(disregard)
Timer 4 expired
(disregard)
Timer 5 expired
(disregard)
Timer 6 expired
(disregard)
Timer 7 expired
(disregard)
Timer 8 expired
(disregard)
(4) J31069-D0416-U001-A5-7618
Positioning
Reserved
Positioning
Axis 1 has reached
setpoint position.
Reserved
Axis 2 has reached
setpoint position.
Reserved
Axis 3 has reached
setpoint position.
Reserved
Axis 4 has reached
setpoint position.
Reserved
CM35 Counter Module