Siemens SIMATIC CM35 Manual page 42

Configuration
Module
address
CM35 Counter Module
(4) J31069-D0416-U001-A5-7618
Note
The latest GSD files (only for COM PROFIBUS version ³ 3.3) can be down-
loaded from the Internet (SIMATIC Customer Support).
Internet address: http://www.ad.siemens.de/support/html_00/index.shtml
Copy the new GSD files to the ²GSD² directory, and execute the menu com-
mand ²File > Open GSD File.²
Using the GSD files included with the configuration package has a drawback
- - you will not be using the latest GSD file (e.g., you may not be able to find
other new modules).
The type files are only required for older COM PROFIBUS
versions £ 3.2. In the future, they will be completely replaced by the
GSD files.
The module is configured as distributed I/O on the SIMATIC S5 with
COM PROFIBUS.
To add a CM35 to an existing DP master system, proceed as shown below.
1. Start COM PROFIBUS, and open the desired master system.
2. Open a DP slave (ET 200M with IM 153-1), or set up a new one.
3. Place the module in the ET 200M. In the configuration table, select the
desired slot, and select the button Order No. ...
In the dialog box ²Select...,² select the order number of the CM35
(6AT1 735-0AA01-0AA0), and select the Accept button.
4. Leave the configuration table open to set the addresses and operating
mode which come next.
You can specify a start address for the input and for the output area. This ad-
dress depends on the operating mode you want to use.
Direct process inputs and outputs: Addresses in the P or Q area
S
Accesses only permitted via word load and transfer operations
Accesses via FB 192: No address specifications required
S
For a detailed description of FB 192 and its manual, see the manual of
COM PROFIBUS.
Address overlapping with other modules or conflicts with reserved areas are
indicated by COM PROFIBUS.
Commissioning
3-19