Removing and installing 2
drive cage (only for the model FUJITSU Desktop
CELSIUS W570power+, with both installation kits)
The procedure for installation kit 1 (for the installation variant with up to two 2
drives, vertical) is identical to that of installation kit 2 (up to four 2
The device variant with installation kit 2 and four drives is shown below.
Installing the hard disk drive
In the cold-plug process, the cables in the casing for the drive automatically lock
into place when the EasyChange rails are activated, as described below.
► Open the drive cage (see
► Secure the EasyChange rails to the side of the hard disk drive by inserting the upper pins
of the EasyChange rail into the corresponding holes of the hard disk. The connections
(a) point to the rear, the label on the drive points to the right.
Fujitsu
"Open the drive cage", Page
a
/
inch hard disks in the
1
2
38).
System expansions
/
inch
1
2
1
/
inch drives,vertical)
2
65