Installing The Power Harness - Toro ProPass 200 Operator's Manual

Figure 6
1. Packing studs and foam
6. Install the hopper guard using the supplied
button-head bolts (1/4 x 5/8 inch) and nylon
locknuts (Figure 7).
Figure 7
1. Hopper front guard
g013207
g030044
2. Bolts
2
Installing the Power
Harness
Parts needed for this procedure:
1 Power harness
1 Socket bracket
1
Socket bracket, heavy
2 Carriage screw
2 Flange nut
2 Screw
2 Flange nut
Procedure
The tow vehicle power harness provides the electrical
power required by the control systems of the machine.
Install this harness on the vehicle you plan to use
to operate the machine. If you will use more than 1
vehicle with the machine, purchase additional power
harnesses from your Toro distributor.
1. Mount the socket bracket to a fixed point at the
rear of the tow vehicle using 1 of the mounting
brackets provided
Note:
Ensure that the bracket will not come
in contact with anything if the tow vehicle is
equipped with a dump box.
Important:
Ensure that none of the wiring
is loose or in the way of any mechanical
components.
10
(Figure 8).