Operating The Floor And Option - Toro ProPass 200 Operator's Manual

Associating the Handheld Remote
with the Base
The factory initially associates the remote to the base
allowing them to communicate; however, there may
be instances in the field when you must reassociate a
remote and a base unit, as follows:
1. Press the E-Stop button to remove power from
the base unit and ensure that the handheld is off.
2. Stand near the base unit in clear line of sight.
3. Simultaneously press and continue to hold the
O /O and the A
N FF
The handheld remote goes through its
initialization screens and settles on ASSOC
PENDING.
4. Continue to hold both buttons and then
quickly release them when ASSOC ACTIVE is
displayed (approximately 4 seconds).
The display will show PRESS STORE.
5. Press and hold the S
The remote displays POW UP BASE.
6. While continuing to hold the S
out on the E-S
TOP
unit.
The handheld remote will associate (link) with
the base unit. Upon success, the display will
show ASSOC PASS.
7. Release the S
TORE
Important:
If the display shows ASSOC EXIT, the
association failed.
Note:
The Handheld Remote and Base Unit link can
be viewed by holding down the A
S buttons at the same time.
TOP
The display will cycle and indicate the selected
channel and the ID of the Base Unit.
S buttons.
LL TOP
+
button.
TORE
button, pull
TORE
button to power up the base
button.
S and O
LL TOP
+
Battery Life, Operating Frequency,
Base and Remote ID Display
Hold down the A
buttons simultaneously to display multiple points of
information.
As you hold the buttons down, the display cycles
approximately every 2 seconds displaying first the
battery life expectancy in percent remaining or current
battery voltage, the operating frequency (channel)
on which the units communicate, then the handheld
remote ID number, and finally the associated BASE
Unit ID.
Operating the Floor and
Option
Use the following procedures to set and operate the
machine floor and option (such as the twin spinner or
other attachment) as follows:
•
Setting and operating the floor alone
•
Setting and operating the option alone
•
Setting and operating both floor and option
together
Setting and Operating the Floor
Alone
Upon initially pressing the F
(when the floor is not running), the remote display
shows the stored setting and an S is displayed after
FLR (i.e. FLRS), indicating that the remote is in a
set-only mode. In this set-only mode, you can adjust
the setting up or down, but the floor does not activate,
remaining off. This allows you to set a desired floor
speed or use the stored setting without causing
unwanted movement. After setting the speed, press
the F S
PTION
LOOR TART
chosen setting (if the hydraulics are engaged, the
floor will start). Press F
store the current value in memory.
Note:
Changes to the foor settings while the floor
is running are immediately effective, but they are
temporary unless you store the new setting by
pressing F
LOOR
setting. For instance, you make an adjustment while
the display shows FLRS, press Floor Start starting the
floor at the adjusted setting, and then turn the remote
off without pressing F
31
S and O
LL TOP PTION
+
S
LOOR TART
button to activate the floor at the
S a third time to
LOOR TART
S again after changing the
TART
S again, storing the
LOOR TART
S
TOP
button