Storage - Toro ProPass 200 Operator's Manual

9. Fully open the rear gate and spray water inside
the hopper assembly and the rear gate area.
Inspect the side seals and replace if necessary.
10. Locate the clean-out decal on the front of the
machine (Figure
through the front guard mesh until the belly pan
is completely clear of material
Note:
When the covers are removed for
greasing, take the opportunity to wash out any
trapped spreading material.
1. Clean-out decal
1. Front clean-out
11. Inspect the hopper, bottom guard, conveyor
belt, bed, and rollers to ensure that all trapped
material is gone.
12. Lower the machine back into the normal
operating position
13. Install the belt cleaning scraper assembly. Push
the scraper mount bar onto the belt. Ensure that
the scraper is as vertical as possible, but still in
contact with the belt.
57), using a garden hose, spray
(Figure 58).
Figure 57
Figure 58

Storage

Before storing the machine for the season, do the
following:
1. Thoroughly clean the machine. Remove parts
if necessary.
2. Remove the handheld remote.
3. Ensure that the emergency stop button is
pushed.
4. Check all fasteners and tighten, if necessary.
5. Grease all fittings and pivot points. Wipe off any
excess lubricant.
6. Lightly sand any painted areas that are
scratched, chipped, or rusted, and apply
touch-up paint.
g013714
7. Store the machine indoors, if possible.
g237531
42