Assembling The Handheld Remote; Mounting The Wireless Remote - Toro ProPass 200 Operator's Manual

7
Assembling the Handheld
Remote
Model 44751 Only
Parts needed for this procedure:
1 Handheld remote
4 AA batteries
1 Magnetic bracket
6 Screws, small
Procedure
1. Remove the rubber bands securing the remote
halves together, and remove the back cover.
2. Install the batteries into the terminal cradle
observing proper polarity. (If the batteries
are improperly installed, the unit will not be
damaged, but it will fail to operate.) The cradle
is embossed with polarity markings for each
terminal (Figure 18).
Figure 18
1. Rubber seal
2. Steel gasket
3. Ensure that the steel gasket and rubber seal are
seated in the channel in the remote and set the
back cover in place
3. Handheld remote
4. 4 AA batteries
(Figure 18).
4. Secure the cover with 6 screws
torque them to 1.5 to 1.7 N∙m (13 to 15 in-lb).
5. Install the handheld remote into the magnetic
remote bracket, slide the halves together to
secure the remote, and tighten the bolt in the
magnet (Figure
1. Handheld remote
2. Magnetic remote bracket
8
Mounting the Wireless
Remote
Model 44751 Only
Parts needed for this procedure:
1 Controller mount assembly
1 Wireless remote assembly
Procedure
Insert the controller mount assembly into a cup holder
g028875
or similar opening on the tow vehicle and use to store
wireless remote. Also, the wireless remote magnet
will stick to any metal component.
14
(Figure
19).
Figure 19
3. Bolt in the magnet
18) and
g028874