Traveling; After Operation Safety; Parking The Machine - Toro ProPass 200 Operator's Manual

WARNING
Unloading the machine when it is not
connected to the tow vehicle may cause the
load to shift and the machine to tip over.
Ensure that the machine is connected to the
tow vehicle before unloading.

Traveling

The machine is designed only for off-road use. The
maximum recommended speed without a load is 24
km/h (15 mph).
Maintain safe control of the machine. Do not attempt
sharp turns, abrupt manoeuvres, or other unsafe
driving actions.
Slow down before turning, especially on wet, sandy,
and slippery surfaces. Turning clearances are limited
if you have an option mounted on the machine.
CAUTION
Using the machine in an unsafe manner could
result in serious injury or death.
Be aware of your surroundings when turning
or backing up. Ensure that the area is clear
and keep all bystanders at a safe distance.
Proceed slowly.
Turn off the option when approaching people,
vehicles, vehicle crossings, or pedestrian crossings.
Note:
Heavy loads and wet or rough surfaces
increase the time it takes to stop, and reduce the
ability to turn quickly and safely.

After Operation Safety

•
Park the machine on a firm, level surface. Avoid
soft ground because the jack leg could sink and
cause the machine to tip over.
•
Do not disconnect the machine from the tow
vehicle on hills, or without engaging the front jack
and rear jack leg.
•
Ensure that the rear jack leg and the hopper are in
the down position. Put a spacer (such as a piece
of wood) underneath the rear leg when the gap to
the ground exceeds 2 inches (5 cm).
•
When disconnecting the machine, always chock
the wheels to prevent movement.
•
Keep all parts of the machine in good working
condition and all hardware tightened.
•
Replace all worn, damaged, or missing decals.

Parking the Machine

Always park the machine on a level surface. Place
blocks under 2 wheels of the machine (front and back
if it is in the vehicle-mounted configuration).
WARNING
Disconnecting the machine from the tow
vehicle on a slope could cause the machine
to move unexpectedly.
Do not disconnect the machine from the tow
vehicle on a slope. Ensure that the front jack
is in the support position.
To rotate the jack stand from a down support position
to a traveling horizontal position, pull out the jack
stand support pin and swivel the jack. Ensure that
the jack stand is attached to the machine and in the
correct position during operation. On Toro tow-behind
chassis the jack stand is located on the hitch tube
(Figure 47). On Truckster direct connect chassis 2
jack stands are used
mounts on the rear of the chassis during operation.
1. Jack stand on tow-behind
35
(Figure 48). Use the jack storage
Figure 47
g013337