Huawei iBattery 3.0 User Manual page 28

iBattery 3.0
User Manual


Figure 3-6 iBOX installation positions in the BCB box
(1) Hall effect sensor



Procedure
Step 1 Remove the battery cabinet panel and knock off the cover on the iBOX indicator hole on the
panel.
Step 2 Install the antenna delivered with the iBOX. Ensure that the antenna is perpendicular to the
floor.
Step 3 Attach the fastener to the positioning frame of the fixing bracket, press the fastener for more
than 10 seconds, and ensure that the fastener is attached firmly and evenly.
Step 4 Mount the iBOX onto the fastener and ensure that the iBOX is securely installed.
Issue 07 (2019-12-30)
In the figure, the circuit breaker panel of the battery cabinet has been removed. Before
removing the circuit breaker panel, knock off the cover on the iBOX indicator hole on the
panel.
If battery cabinets are combined, remove the side panels between the battery cabinets.
Before attaching the iBOX fastener to the installation position, clean the dust at the
installation position.
Install the iBOX on the corresponding BCB box.
Install the iBOX using an adhesive fastener, and then mount the iBOX onto the fastener.
The following describes how to install an iBOX in a battery cabinet.
Copyright © Huawei Technologies Co., Ltd.
(2) iBOX
3 Installing Devices
(3) BIB
22