Error Code List - Panasonic EP-MA03 Service Manual

Massage lounger
Table of Contents

Advertisement

6.11.

Error code List

If there are any malfunction on each Sensors, each Motors, and power source and data communication lines in the operations, the
following displays blink and the all the operations stop.
Use them for the reference in the repair.
Error code
F04
F05
F06
F08
F11
F12
F33
F34
F35
F36
F37
F15
F16
F14
F80
F81
*1 You need to operate the Secret mode to remove the errors of F04 to F06, and F08.
(Users cannot remove the errors.)
However, you can move up and down the Ottoman/Reclining lift units.
Malfunction
Heater error
Heater unit error (Thermistor disconnection)
(Thermistor disconnection)
Heater error
Heater unit error (Thermistor short-circuit)
(Thermistor short-circuit)
Heater error
Sub PCB error (Trisistor short-circuit)
(Trisistor short-circuit)
Heater sensor wire short-
Heater unit error (Heater sensor wire short-circuit)
circuit error
Data communication error Connector connection error of Connecting PCB, Sub
PCB, and Controller, Connecting cord disconnection,
damage parts, etc.
Sub PCB MPU frequency
Sub PCB error
sensor error
Tapping sensor
Sensor connector coming-off, Lead disconnection,
parts damage, Connecting cord for power source dis-
connection, Sub PCB relay error, etc.
Ottoman sensor
Connector coming-off, Lead disconnection, parts dam-
age, Sub PCB relay error
Reclining sensor
Connector coming-off, Lead disconnection, parts dam-
age, Sub PCB relay error
Massaging (width) sensor Sensor connector coming-off, Lead disconnection,
parts damage, Connecting cord for power source dis-
connection, Sub PCB relay error, etc.
Up/down sensor
Sensor connector coming-off, Lead disconnection,
parts damage, Connecting cord for power source dis-
connection, Sub PCB relay error, etc.
Ottoman motor
Stalling by mechanical overload (Connector coming-off,
open circuit are detected as sensor error.)
Reclining motor
Stalling by mechanical overload (Connector coming-off,
open circuit are detected as sensor error.)
Tapping motor
Stalling by mechanical overload (Connector coming-off,
open circuit are detected as sensor error(F33).)
Massaging motor
Stalling by mechanical overload (Connector coming-off,
open circuit are detected as sensor error(F36).)
Up/down motor
Stalling by mechanical overload (Connector coming-off,
open circuit are detected as sensor error(F37).)
Possible reasons
22
Notes
* 1
* 1
* 1
* 1

Advertisement

Table of Contents
loading

Table of Contents