Panasonic EP-MA03 Service Manual page 47

6. Cut two cable ties and remove one Massage mechanism
block cover clip and two screws and remove the Massage
mechanism block cover.
7. Remove each Lead wire and remove the Massage mech-
anism block totally.
Caution in installing:
Install the Guide roller spring, Washer, and Guide
roller in order.
Install the Guide roller spring with its straight end on
the side of the Washer.
Otherwise, it may lead to the abnormal noise when in
up/down operation.
If you cannot move the Massage mechanism block up and
down due to the malfunction of the Up/down motor, move
the Massage mechanism block as follows;txt
1. Necessary products
Air hose x 1pc (approx. 8cm)
Bit x 1pcs (approx. 8cm)
Electric screwdriver x 1pc
As the figure, install the air hose on the bit.
2. Place the air hose-covered bit on the Up/down motor
rotation sensor plate, and turn on the electric screwdriver.
Caution:
Operate the electric power tool at low speed.
*Be careful of the cords or sharp metal edges.
47