Table of Contents
Advertisement
NTFC Menu⎯Modifying the Physical Port Default Settings
To modify the physical port default settings:
1
Select INTFC on the MAIN menu and then press
illustrated in Figure 4-4:
Figure 4-4
INTFC menu
A
E
2
Press
or
to select the port to configure and then press
3
Use Table 4-4 to set up ports 2, 4, 5, and 6. The table describes the configurable menu items
for these ports.
4
After configuring the menu items, select UP and then press
Table 4-4 describes the fields and available options:
Table 4-4
Configuring the physical ports
Key
Field
Description
A
INTFC:
Identifies the menu.
B
1 CONSOLE
Displays the internal console settings for
the rear panel. It provides asynchronous communications at 9600 baud and cannot be
reconfigured at the front panel. It is used only for maintenance.
C
2 530/232
Configures the operating parameters for
asynchronous communications, and the data rate is configured from 300 bps through
19.2 Kbps.
D
3 ENET
Displays the operating parameters for
address; a selection for the Time-To-Live (TTL) setting, a selection for enabling or
disabling IGMP, and a menu selection for the multicast MAC receive address assigned
to the OM 1000 at the factory.
E
UP
Displays the MAIN menu.
F
4
Configures the operating parameters for optional
options as described for
external clock, or slv on rx clock). The INTFC menu displays UNEQPD if the
communications board is not present and configured. Refer to the operate.txt file in
Appendix C, "Initialization Information."
B
F
G
2, if present. Select async or sync (internal clock,
PORT
Setup and Operation
to display the INTFC menu
ENT
C
D
H
.
ENT
to display the MAIN menu.
ENT
1. The console port is accessible from
PORT
2. This port is configured for
PORT
3. A display-only field displays the MAC
PORT
4. Configure the data and baud
PORT
OM 1000 Installation and Operation Manual
4-9
I
Advertisement
Table of Contents
