4-12
Setup and Operation
3
If you select SYNC, press
RX CLK. The INTFC menu displays UNEQPD if the communications board is not present
and configured.
4
Select DATA RATE, press
(bit) rate table in Appendix A, "Specifications" for valid values.
INTFC 6 Menu⎯Setting Up
To set up the RF modulator, you must:
Enable the modulator output mode
Set the output frequency
Set the output signal level
Figure 4-7 illustrates the process that you must follow to set up the modulator port. Default
settings are shown in bold:
Figure 4-7
Setting up the RF modulator
OM 1000 Installation and Operation Manual
or
to select INTERNAL CLK, EXTERNAL CLK, SLV, or
or
to select the rate, and then press
6 (RF Modulator)
PORT
INTFC
RF
menu Modulator
modulator
selection
setup menu
6 MOD
INTFC menu
Output signal
ENT
71.00
•
•
•
Port
75.25
selection
•
•
•
129.00
Back to
UP
Modulator
mode
1
•
•
•
35
level
•
•
•
40
. Refer to the data