Intfc 4/ Intfc 5 Menu⎯Setting Up Ports 4 And 5 (Optional Rs-530/Rs-232); Figure 4-6 Rcv Mcast Menu - Motorola OM 1000 Installation And Operation Manual

2
Select RCV MCAST to display the default multicast MAC receive address and the
corresponding multicast receive IP address, as illustrated in Figure 4-6:
Figure 4-6
RCV MCAST menu
The multicast receive IP address is automatically calculated by the
default multicast MAC receive address.
The default multicast MAC address is used to receive non-standard multicast datagrams.
Non-standard multicast datagrams are sent to the
a multicast MAC address. The default receive multicast MAC address is configurable
through the config.ini file only.
3
Select the TTL field (multicast transmit TTL setting), press
then press . To apply a new TTL setting, save the setting and reboot the
ENT
4
Select the IGMP field, press
selection enables or disables support for IGMP version 1.) To apply a new IGMP setting,
save the setting and reboot the
Table 4-5 describes the Ethernet interface menu options:
Table 4-5
Ethernet interface menu options
Key Field
A INTFC 3
B ENET UDP MAC
C
UP
D RCV MCAST
E TTL
F IGMP
INTFC 4/ INTFC 5 Menu⎯Setting Up Ports 4 and 5 (Optional RS-530/RS-232)
Optional and
PORT 4 PORT 5
before being available for setup in these menus. Refer to the operate.txt file in Appendix C,
"Initialization Information" for configuration information.
To configure operating parameters for
1
Select 4 (530/232) and then press
2
Select ASYNC or SYNC.
or to select enable or disable and then press
1000.
OM
Options Description
Identifies this menu as the Ethernet interface menu.
Identifies the MAC address of the OM 1000.
Displays the previous menu.
Displays the multicast receive menu.
000 through 255 Sets the multicast transmit TTL value. The OM 1000 must
then be rebooted before any changes are applied.
ENABLE Enables or Disables IGMP. The OM 1000 must then be
DISABLE rebooted before any changes are applied.
modules must be installed and configured in the initialization file
4 and 5:
PORT
.
ENT
Setup and Operation
1000 based on the
OM
1000 with a broadcast IP address and
OM
or to set the TTL, and
OM 1000 Installation and Operation Manual
4-11
1000.
OM
. (This
ENT