Install The System Cover - Dell EMC Integrated Data Protection Appliance DP4400 Service Manual

Install the system cover

CAUTION
When a replacement hot swappable hard drive is installed and the system is
powered on, the hard drive automatically begins to rebuild. Ensure that the
replacement hard drive is blank or contains data that you wish to overwrite. Any
data on the replacement hard drive is immediately lost after the hard drive is
installed.
Procedure
1. Lift the hard carrier handle.
2. If a hard drive blank is installed in the hard drive slot, remove it.
3. Insert the hard drive carrier into the hard drive tray.
4. Lower the hard drive carrier handle to engage the hard drive to the connector
on the backplane and lock the hard drive in place.
Figure 15 Installing hard drive carrier into mid hard drive tray
Procedure
1. Align the tabs on the system cover with the guide slots on the system.
2. Push the system cover latch down.
The system cover slides forward, the tabs on the system cover engage with the
guide slots on the system and the system cover latch locks into place.
3. Using a flat or Phillips head screwdriver, rotate the latch release lock clockwise
to the locked position.
Remove and replace assemblies
Install the system cover
29