Install The System Cover; Slide The System Into The Cabinet - Dell EMC Integrated Data Protection Appliance DP4400 Service Manual

Install the system cover

Slide the system into the cabinet

3. Insert the BOSS card edge connector firmly into expansion card slot 3 until the
card is fully seated.
4. Push the expansion card latch into the slot.
Figure 38 Installing the BOSS card in expansion card riser 1
Procedure
1. Align the tabs on the system cover with the guide slots on the system.
2. Push the system cover latch down.
The system cover slides forward, the tabs on the system cover engage with the
guide slots on the system and the system cover latch locks into place.
3. Using a flat or Phillips head screwdriver, rotate the latch release lock clockwise
to the locked position.
Figure 39 Install System cover
Procedure
1. At the front of the cabinet, push the system inward until the lock levers click
into place.
Remove and replace assemblies
Install the system cover
49