Slide The System Into The Cabinet; Connect The I/O Cables And Power Cords - Dell EMC Integrated Data Protection Appliance DP4400 Service Manual

Remove and replace assemblies

Slide the system into the cabinet

Connect the I/O cables and power cords

Dell EMC Integrated Data Protection Appliance DP4400 2.4 Service Procedures Guide
58
Figure 49 Install System cover
Procedure
1. At the front of the cabinet, push the system inward until the lock levers click
into place.
2. Push the blue slide release lock tabs forward on both rails and slide the system
into the cabinet. The slam latches will engage to secure the system in the
cabinet.
Figure 50 Slide the system into the cabinet
This procedure is used to connect the peripherals and power to the system.
Procedure
1. Using the connection information recorded on the labels, connect the I/O
cables to the system.
2. Plug the power cords into the power supplies.