Install the system cover
Note
Store the filler bracket for future use. Filler brackets must be installed in empty
expansion card slots to maintain Federal Communications Commission (FCC)
certification of the system. The brackets also keep dust and dirt out of the
system and aid in proper cooling and airflow inside the system.
4. Hold the network interface card by its edges, and align the card edge connector
with the expansion card connector on the riser.
5. Insert the card edge connector firmly into the expansion card connector until
the card is fully seated.
6. Push the expansion card latch into the slot.
Figure 48 Installing the BOSS card in expansion card riser 1
Procedure
1. Align the tabs on the system cover with the guide slots on the system.
2. Push the system cover latch down.
The system cover slides forward, the tabs on the system cover engage with the
guide slots on the system and the system cover latch locks into place.
3. Using a flat or Phillips head screwdriver, rotate the latch release lock clockwise
to the locked position.
Remove and replace assemblies
Install the system cover
57