Troubleshooting - Philips HD2137 Manual

Troubleshooting

Problem
I have difficulties
opening the lid
after cooking
I have difficulties
closing the top lid
Leaking from under lid
Leaking from floater
Floater does not rise up
after the appliance
starts pressurising.
E3 is displayed on the screen.
E1, E2, or E4 is displayed on the screen.
To see more 'How to use videos', please visit www.philips.com.au or www.philips.co.nz
8
Cause
Need to release the pressure
Floater stuck in up position
The sealing ring is not well assembled.
Floater stuck in up position
Sealing ring missing
Food or debris under sealing ring
Lid not correctly closed
Sealing ring broken
Food or debris under sealing ring
Food & Water are below minimum level
Leaking from lid or pressure control valve
The temperature inside the inner pot is too high.
The all-in-one cooker has malfunction.
Solution
Pressure
Floater
Control Valve
Set the pressure control valve to 'Vent'.
And wait until the floater has dropped.
Set the pressure control valve to 'Vent'.
And wait until the floater has dropped.
Make sure the sealing ring is well
assembled around the inner lid.
The floater blocks the locking pin. Push down the
floater so that it does not block the locking pin.
Sealing ring
Inner lid
Put sealing ring in place correctly on inner lid.
Remove sealing ring, clean and replace.
Open and reclose lid, checking for correct closing.
Replace sealing ring.
Remove sealing ring, clean and replace.
Add food/water. Make sure there is enough
food and water in the inner pot.
Take the appliance to Philips service centre.
Wait until it falls down to room temperature
Take the appliance to Philips service centre.
Sealing ring
Inner lid