Table of Contents
Advertisement
(4) User program download
When a user program is downloaded into the user RAM, use the ml command. As shown below, enter "ml" at
the command prompt.
Ready > ml
After command entry, the following transfer request message is output from the monitor program, and the
message is displayed on the host system screen.
Please Send A S-format Record
When the above message is displayed, send the S format object file by using the file transfer function of the
communication software.
The S format object file has been provided with address information, and the object program is located according
to this information.
When the object file has no address information, i.e., it is a relocatable file, specify an offset address with the ml
command.
This offset address must be within a user area shown in Figure 10.1. Upon completion of file loading into
memory, the following message is displayed on the screen of the host system. (In this example, the program has
been loaded from the address h'AC100000 in area 3.)
Ready >ml
Please Send A S-format Record
Start Addrs = AC100000
End Addrs = AC1000BC
Transfer complete
Ready >
119
Advertisement
Table of Contents
