Hitachi SH7760 Solution Engine2 Overview page 24

2.4.3 Debug Board Jumper Switches
Table 2.2 describes a method for setting the EPROM selection jumper switch (J1) on the debugger board. For
details of a memory map during debug board connection, refer to 4. "Memory Map."
Jumper Setting
switch
J1
1
Pins 1 and 2 are short-circuited.
1
Pins 1 and 2: OPEN
Table 2.2 Setting the EPROM Selection Jumper Switch (J1)
Description
Debug board resources are assigned to area 0 on the SH7760 board as
2
shown below. (Factory setting)
- The EPROM mounted on the debug board is assigned to an address range from
h'00000000 to h'001FFFFF.
- The 8-bit LEDs mounted on the debug board are assigned to an address range
from h'00400000 to h'007FFFFF.
- The 16-bit LEDs mounted on the debug board are assigned to an address range
from h'00800000 to h'00BFFFFF.
- The flash memory of Solution Engine2 is assigned to an address range from
h'01000000 to h'017FFFFF.
Debug board resources are assigned to area 0 on the SH7760 board as shown
2
below.
- The flash memory of Solution Engine2 is assigned to an address range from
h'00000000 to h'007FFFFF.
- The EPROMs mounted on the debug board are assigned to an address range
from h'01000000 to h'011FFFFF
- The 8-bit LEDs mounted on the debug board are assigned to an address range
from h'01400000 to h'017FFFFF.
- The 16-bit LEDs mounted on the debug board are assigned to an address range
from h'01800000 to h'01BFFFFF.
21