Overview; Precautions For Disassembling The Printer - Epson Stylus COLOR 900 Service Manual

EPSON Stylus COLOR 900/900N

4.1 Overview

This chapter describes procedures for disassembling the main
components of the EPSON Stylus Color 900/900N. Unless otherwise
specified, disassembly units can be reassembled by reversing the
disassembly procedure.

4.1.1 Precautions for Disassembling the Printer

Familiarize yourself with the precautions listed below, and then read
instructions marked "WARNING" or "CAUTION" before performing any
disassembly procedure.
Instructions labeled "CHECK POINT" include special tips to help you
assemble or disassemble the printer.
Chapter 4 Disassembly and Assembly
T
Disconnect the power cable before disassembling or
W A R N I N G
assembling the printer.
T
Wear protective goggles to protect your eyes from ink
and flying parts. If ink gets in your eyes, flush your
eyes with water and see a doctor immediately.
T
If ink comes in contact with your skin, wash it off with
soap and water. If irritation occurs, contact a
physician.
T
A lithium battery is installed on the main board of this
printer. Be sure to observe the following instructions
when handling the battery:
T
Keep the battery away from any metal or other
batteries so that electrodes of the opposite polarity do
not come in contact with each other.
T
Do not heat the battery or put it in fire.
T
Do not solder on any part of the battery. (Doing so may
result in leakage of electrolyte from the battery, fire, or
explosion.)
T
Do not charge the battery, since this may cause the
battery to explode.
T
Do not dismantle the battery. (The gas inside the
battery may hurt your throat. Leakage, burning, or
explosion may also result.)
T
Do not install the battery in the wrong direction. (This
may cause fire or explosion.)
87