Wall-Mounted Installation - Fujitsu GW1500 Getting Started Manual

GW1500 Getting Started Guide
2.2.2 Table-Top Installation
The device can be placed on a flat table.
Prepare the rubber feet (x4) and screws (x4) that are included.
Caution
- Do not place the device vertically. Doing so may fall components and
cause injuries, damage, or device failures.
- Do not install other devices on top of this device. The device may become
hot, resulting in failures or affecting the life cycle of the device.
[Installation Procedure]
1. With base surface of the device facing up, place it on a flat place.
2. Attach the rubber feet to the corners of the device on the base surface.
3. Use the screws to fasten the rubber feet.
4. With the rubber feet attached, install the device on a flat table.
2.2.3

Wall-Mounted Installation

The device can be mounted on a flat wall.
The device can be mounted on a wall using the following two methods:
- Using the Magnet Sheet
- Using the Wall-Mounting Equipment
Rubber Foot
25 Chapter 2 Device Installation