Table of Contents
Advertisement
GW1500 Getting Started Guide
[Setting Procedure]
1.
Execute the instrument license key command to set the license information.
For the command option, enter the license key (16 alphanumeric characters). If you have
purchased multiple instrument management licenses, perform this operation on each
license. The license key is written on the "License Agreement" for the instrument
management license.
The following is an example of entering the license key. Enter the correct license key in
the underlined section.
(config)# instrument license key xxxxxxxxxxxxxxxx
A "License Agreement" is necessary to restore the configuration definition
information, such as to replace a device due to a device failure. Keep it in a
Tips
safe place.
2.
Confirm that the license information is applied correctly.
Use the show instrument license command.
The following shows an example where, in addition to the initial 10 instruments, the
customer purchased a "Instrument management 10 license" (20 instruments can be
connected in total).
# show instrument license
registered license key:
xxxxxxxxxxxxxxxx license : 10
assigned
remaining
registered
#
3.5.4
Setting the Device IP Address
Change the device IP address as necessary to suit your network environment.
[Setting Procedure]
1.
Execute the lan ip address command to set the device IP address.
Command input format:
lan [<number>] ip address [<count>] <address>/<mask> <broadcast>
(config)# lan 2 ip address 1 192.168.1.1/24 0
You can use the default IP address. If you change the device IP address,
change the IP address of the setup computer as well.
Tips
license
count
license
count
instrument
count
: 20
: 18
: 2
40
Chapter 3 Device Settings
Advertisement
Table of Contents
