Fujitsu GW1500 Getting Started Manual page 29

GW1500 Getting Started Guide
3. Install the wall-mounting equipment with the device fastened to the wall.
Install it to the wall by fastening four M4 screws for sections A and two M5 screws for
sections B.
Screws are not included, so you have to prepare them.
Wall
(A)
Attention!
- After installing it on the wall, confirm that it is firmly installed to prevent it from
falling.
- Do not install it in a location where it may fall and hurt human body.
- Do not install it in a location with excessive vibrations or impacts, or an
unstable location. Doing so may cause injuries or device failure.
- Install cables firmly, so that the device does not fall due to the weight of the
cables. Not installing cables firmly enough may cause injuries or device failure.
- Fasten the cables so that the LAN cable, DC cord, or AC adapter cord do not
touch human bodies or chairs.
- For the orientation of the device when attaching it to a wall using the wall-
mounting equipment, refer to
using the wall-mounting equipment, the device can be installed with its rear
(ETH port side) facing towards the ceiling.
(B)
" Using the Magnet Sheet" on page
29
(A)
26. When
Chapter 2 Device Installation