Huawei PowerCube 5000 User Manual page 28

PowerCube 5000
User Manual (SmartLi 100Ah)
Figure 2-9 Appearance
(1) Positioning lock
(3) Indicators
Table 2-3 Indicator description
Indicator
Power indicator
Alarm indicator
Fault indicator
Issue 02 (2020-03-17)
 The power supply can be manually connected only if the battery cold start button is held down for 5s
at least.
 A short circuit in the BPS power supply to loads may cause a DG output short circuit.
Color
Green
Yellow
Red
Copyright © Huawei Technologies Co., Ltd.
(2) Ready switch
(4) Battery cold start button
Status Description
Steady on The system is working in bypass
mode.
Blinking The bypass has no output (blinking at
slowly 0.2 Hz, on for 2.5s and off for 2.5s).
Blinking The bypass is not configured or the
fast DSP software is being upgraded
(blinking at 4 Hz, on for 0.125s and
off for 0.125s).
Off The bypass CPLD software is being
upgraded.
Steady on A minor alarm is generated for the
bypass.
Off There is no minor alarm for the
bypass, or the CPLD software is being
upgraded.
Steady on A critical alarm is generated for the
bypass.
Off There is no critical alarm for the
bypass, or the CPLD software is being
upgraded.
2 Products
20