Operation
After connecting the power cord, press the On/Off button after it
●
passes for more than 10 seconds.
Switching the server node on
The AC connected indicator lights up green (standby mode) when the server is
connected to the mains.
I
It will take about 60 seconds until the server node can be switched on.
Ê Press the On/Off button.
The server node is switched on, performs a system test and boots the
operating system.
I
In the case of configurations with a large memory size, the boot
process may be prolonged and the screen may remain dark for
several minutes.
Switching the server node off
The power-on indicator lights up green.
Ê Shut down the operating system properly.
The server node is switched off automatically and enters standby mode. The AC
connected indicator lights up green.
I
If the operating system does not turn off the server automatically, press
the On/Off button for at least four seconds and/or send a corresponding
control signal for power button override.
V
CAUTION!
There is a risk that data may be lost.
Other On/Off options
Besides the On/Off button, the server node can be switched ON and OFF in the
following ways:
– Wake up On LAN (WOL)
The server node is switched on by a command via the LAN (Magic
Packet™).
64
Operating Manual
CX400 M4