Operation
6.2
Removing 2.5-inch HDD/SSD modules
6.2.1
Removing a 2.5-inch HDD/SSD module
Figure 27: Installing the 2.5-inch HDD/SSD module
Ê Pinch the green locking clips (1) and open the locking lever (2).
Ê Pull the HDD/SSD module out a few centimeters (3).
Ê Wait about 30 seconds to allow the HDD to spin down.
I
This is not necessary when removing an SSD.
I
This period is necessary for the RAID controller to recognize that an
HDD module has been removed and for the HDD to come to a stop.
Ê Pull the HDD/SSD module completely out of its bay.
66
Operating Manual
CX400 M4