Removing The Hot-Plug Psu - Fujitsu PRIMERGY CX400 M4 Operating Manual

Operation
6.3

Removing the hot-plug PSU

Figure 29: Removing the PSU
Ê Push the handle of the PSU halfway upward in the direction of the arrow (1).
Ê Press in on the green locking latch (2).
Ê While keeping the green locking latch pressed, pull the PSU out of its bay
(3).
V
CAUTION!
Never leave the bay for the hot-plug PSU empty for more than two
minutes during operation. Otherwise, excessive temperatures could
damage system components.
The hot-plug PSU is in installed in the reverse order.
68 Operating Manual
CX400 M4