Table of Contents
Advertisement
Installation References
Installing Elliptical Waveguides
d
Laying Out and Installing an Elliptical Waveguide
Securing the elliptical waveguide
a. Assembling fixture
b
Secure the elliptical waveguide.
a. Install a clamp onto the elliptic waveguide.
Install clamps at 1m (3.28 ft) intervals in the horizontal or vertical direction.
Install clamps at the two ends of each bent part.
b. Screw
Install clamps.
8mm (0.3 in.)
b. Tighten the screw on the clamp until the gap is 8
mm (0.3 in.).
Connecting the elliptical waveguide
Connect the elliptical waveguide to the branching unit.
SD antenna port
Elliptical
waveguide
Connect the flexible waveguide to the antenna.
6 GHz antenna
Spacer
Flexible
waveguide
c
Connect the elliptical waveguide to the flexible
waveguide.
Elliptical
waveguide
Spacer
Through-hole
22
Blind via
Antenna
Flexible
waveguide
A spacer is required when a flexible waveguide is
connected to a 6 GHz antenna.
A spacer is required when an elliptical waveguide is
connected to a flexible waveguide.
When elliptical waveguides, flexible waveguides, antennas,
and branching units are connected, fix long screws into
through-holes and short screws into blind vias.
Fasten all screws for connecting elliptical waveguides,
flexible waveguides, antennas, and branching units.
Hide quick links:
Advertisement
Table of Contents
