Installation Precautions in a Harsh Environment
Definition of harsh environment
Within 3.7 km (12139 ft ) of an ocean or a salt water lake
When outdoor equipment or cabinets are installed in a harsh environment, ensure that the following requirements
are met:
Antenna installation requirements
If glue dispensing is not done on the rivets or screws of the center plate and reflective surface of an antenna
before delivery, apply matching outdoor adhesive to them.
Apply thread adhesive to screws used for installing antennas. This can prevent the screws from becoming
loose and improve corrosion resistance.
After you finish installing screws, spread oil or spray paint on the surface of the screws.
In areas with many birds, install protective covers to prevent birds' droppings from corroding antennas.
Branching unit installation requirements
Spread oil or spray paint onto the clamps of flexible/elliptical waveguides.
After you finish installing exposed screws, spread oil or spray paint on the surface of the screws.
In areas with many birds, install protective covers to prevent birds' droppings from corroding branching units.
IDU cabinet installation requirements
Outdoor cabinets must be equipped with heat exchangers or air conditioners.
The air exhaust vent of an air conditioner must not face equipment.
Equipment rooms must be airtight. Equipment rooms and dust filters of equipment must be cleaned regularly.
Equipment room doors must not face the wind.
Install filler panels in vacant slots of the IDU to prevent dust accumulation in the slots and corrosion caused by
salt fog.
2