Connecting To Web-Based Interface - D-Link DAP-1155 User Manual

DAP-1155 Wireless N150 Access Point & Router
User Manual

Connecting to Web-based Interface

When you have configured your computer, you can access the web-based interface and configure
needed parameters (create a WAN connection, change the parameters of the wireless network,
specify the settings of the firewall, etc.).
Start a web browser (see the Before You Begin section, page 12). In the address bar of the web
browser, enter the IP address of the access point (by default, the following IP address is specified:
192.168.0.50). Press the Enter key.
Figure 15. Connecting to the web-based interface of the DAP-1155 device.
If the error " The page cannot be displayed " (or " Unable to display the page "/" Could not
!
connect to remote server ") occurs upon connecting to the web-based interface of the access
point, make sure that you have properly connected the device to your computer.
After the first access to the web-based interface you need to change the default administrator
password. Enter the new password in the Password and Confirmation fields. You may set any
password except admin. Use digits, Latin letters (uppercase and/or lowercase), and characters
available on the keyboard. Then click the Apply button.
Figure 16. The page for changing the default administrator password.
Remember or write down the new password for the administrator account. In case of losing
!
the new password, you can access the settings of the access point only after restoring the
factory default settings via the hardware WPS/RESET button. This procedure wipes out
all settings that you have configured for your access point.
When the web-based interface is accessed the next time and after, the login page opens. Enter the
username (admin) in the
click the Enter button.
Login field and the password you specified in the
Figure 17. The login page.
Page 25 of 158
Installation and Connection
Password field, then